If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. 3. Personal safety a. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the in uence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. b. Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. c. Prevent unintentional starting.Page 4
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.Page 5
To reduce the risk of injury, the user must read the instruction manual. Additional safety instructions for batteries and chargers Batteries u Never attempt to open for any reason. u Do not expose the battery to water. u Do not expose the battery to heat. u Do not store in locations where the temperature may exceed 40 C. u Charge only at ambient temperatures between 10 C and 40 C. u Charge only using the charger provided with the tool. u When disposing of batteries, follow the instructions given in the section "Protecting the environment". Chargers u Use your Black & Decker charger only to charge the battery in the tool with which it was supplied.Page 6
Generally, a charging time of 8 hours will enable the tool to operate at an effective power level for most tasks. However, further charging for up to 10 hours could signi cantly increase the run time, depending on the battery and charging conditions. Warning! Do not charge the battery at ambient temperatures below 4 C or above 40 C. Selecting the direction of rotation For tightening screws, use forward (clockwise) rotation. For loosening screws use reverse (counterclockwise) rotation. u To select forward rotation, push the forward/reverse slider (2) to the left. u To select reverse rotation, push the forward/reverse slider (2) to the right.Page 7
Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before cleaning it. u Regularly clean the ventilation slots in your tool and charger using a soft brush or dry cloth. u Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner. Protecting the environment Z Separate collection. This product must not be disposed of with normal household waste. Should you nd one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not dispose of it with household waste. Make this product available for separate collection.Page 8
This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
|File size:||921.98 KB|