hammer tackers in three (3) models: 6000 Heavy Duty Hammer Tacker, 6100 T-Head Hammer Tacker, and 6200 Jumbo Hammer Tacker. With proper use and care the hammer tacker will give you many years of reliable performance. For safe operation and best performance, please read all safety rules and instructions carefully before using the hammer tacker. Be sure to send in your registration card.Page 3
TO MINIMIZE THE RISK OF INJURY, ALWAYS WEAR GLOVES AND USE EYE PROTECTION. When using mechanical tools basic safety precautions should always be followed to reduce the risk of personal injury, including the following: READ ALL INSTRUCTIONS 1. DO NOT SWING THE HAMMER TACKER IN THE DIRECTION OF OTHERS. Be cautious of others that may be behind you. 2. ALWAYS USE THE PROPER STAPLE SIZE. This product accepts .05" wire gauge heavy duty staples only. Do not try to use light duty (.03"), desk or wire staples in this product. 3. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. 4. CONSIDER WORK AREA ENVIRONMENT. Don’t expose tool to rain. Keep work area well lit. 5. KEEP CHILDREN AWAY.Page 4
Using Your Tacker Selecting the Right Staple: To maximize performance, your tacker has been designed to work with genuine heavy duty staples in various lengths from 1/4 inch to 9/16 inch (see chart for what size staple fits each Hammer Tacker model). tackers are also compatible with other brands of heavy duty narrow crown staples such as Arrow heavy duty staples. Selecting the Right Staple Length: As a general guideline, when stapling into wood, allow for leg penetration of approximately 3/16" to 1/4”.Page 5
the staples and feeder strip as indicated in the loading instructions section. Chamber Cleaning Instructions for Model 6100 (Fig. the feeder strip as indicated in the loading instruction all screw and nut from hole A. (Fig. down entire inside frame for complete cleaning. (Fig 8). Operating Instructions for model # 6100,6200 Hold the hammer tacker in the hand as you would a conventional hammer. Select the area to be stapled and bring the tacker down in a hammer striking motion. The imapct of the hammer tacker on the stapling surface will fire a staple and move the next staple forward into firing position.Page 6
COMMON APPLICATIONS FOR STAPLE LENGTH: 1 4" Plastic Sheeting, Cardboard, Roofing Paper 5 16" Insulation, Cloth, Light Plastics, Foam Rubber, Roofing Paper 3 8" Carpeting, Shingles, Roofing Paper 1 2" Felt Stripping, Fiberglass, Carpet Underlayment 9 16" Roof Covering, Insulation Board, Carpet Underlayment 5 Staple Selection Guide For best results the Hammer tacker has been designed to use heavy duty .05" crown width staples. It will also accept other .05" crown width heavy duty staples, including Power Arrow staples. are registered trademarks of Arrow Fastener Company.
|File size:||127.31 KB|