This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, re and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. 1. Work area safety a. Keep work area clean and well lit. Cluttered or dark areas invite accidents. b.Page 4
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.Page 5
Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, re and/or serious injury. Additional safety instructions for batteries and chargers Batteries u Never attempt to open for any reason. u Do not expose the battery to water. u Do not store in locations where the temperature may exceed 40 C. u Charge only at ambient temperatures between 10 C and 40 C. u Charge only using the charger provided with the tool. u When disposing of batteries, follow the instructions given in the section "Protecting the environment". p Do not attempt to charge damaged batteries.Page 6
Let the tool work at its own pace. Do not overload. Charging the battery ( g. A) The battery needs to be charged before rst use and whenever it fails to produce suf cient power on jobs that were easily done before. The battery may become warm while charging; this is normal and does not indicate a problem. Warning! Do not charge the battery at ambient temperatures below 10 C or above 40 C. Recommended charging temperature: approx. 24 C. Note: The charger will not charge a battery if the cell temperature is below approximately 0 C or above 40 C. The battery should be left in the charger and the charger will begin to charge automatically when the cell temperature warms up or cools down.Page 7
ENGLISH (Original instructions) You can check the location of your nearest authorised repair agent by contacting your local Stanley Europe of ce at the address indicated in this manual. Alternatively, a list of authorised Stanley Europe repair agents and full details of our after-sales service and contacts are available on the Internet at: www.2help U.com Batteries Z Stanley Fat Max batteries can be recharged many times. At the end of their useful life, discard batteries with due care for our environment: u Run the battery down completely, then remove it from the tool. u Ni Cd, Ni MH and Li-Ion batteries are recyclable. Take them to any authorised repair agent or a local recycling station.
|File size:||1.22 MB|